Tuning Z-Probe Offset

USER GUIDE K

Tuning Z-Probe Offset

Step-by-step guide to tune the bed-leveling probe offset.

Step 1

NAVIGATE TO PREPARE MENU

While the printer is not printing, go to the Prepare Menu.

Step 2

SELECT BED LEVELING FROM PREPARE MENU

Select Bed Leveling from the Prepare Menu.

Step 3

NAVIGATE TO Z-PROBE OFFSET

Navigate to Z Probe Offset and click the control knob.

Step 4

SET NEW OFFSET VALUE

Adjust the offset value up or down by spinning the control knob. To set the value click the control knob.

IMPORTANT NOTE

If the nozzle is consistently too close to the build platform, you will want to raise the offset value (ie. from -1.5 to -1.4). If the nozzle is consistently too far from the build platform, you will want to lower the offset value (ie. from -1.5 to -1.6). We recommend tuning in increments of 0.1mm and testing between each adjustment.

Step 5

STORE NEW SETTING

Scroll down to Store Settings and click the control knob. When you hear the chime the setting has been stored.

Step 6

TEST NEW OFFSET VALUE

Start your next print and watch the outline of the first layer. If the layer height is good, you are all set. If the layer height is still too close or two far away repeat the above steps.

Learn something? Share it:
MAIN MENU
Anything's Possible™